User guide

C HAPTER 3 | Installing the Access Point/Repeater
Mounting the Device
– 24 –
MOUNTING THE DEVICE
The Wireless-N Access Point/Repeater can be mounted on any horizontal
surface, or on a wall. The following sections describe the mounting options.
MOUNTING ON A WALL The Wireless-N Access Point/Repeater should be mounted only to a wall or
wood surface that is at least 1/2-inch plywood or its equivalent. To mount
the unit on a wall, always use its wall-mounting slots. The unit must be
mounted with the RJ-45 cable connector oriented upwards to ensure
proper operation.
Figure 7: Wall Mounting
To mount on a wall, follow the instructions below.
1. Mark the position of the two screw holes on the wall. For concrete or
brick walls, you will need to drill holes and insert wall plugs for the
screws.
2. Insert two 20-mm M4 tap screws (not included) into the holes, leaving
about 2~3 mm (0.08~0.12 inches) clearance from the wall.
3. Line up the two mounting points on the unit with the screws in the wall,
then slide the unit down onto the screws until it is in a secured position.
Mounting Slots