User guide

Using the Setup Wizard

4-13

• L2TP Network Mode: Sets a L2TP network mode. (Default: DHCP)

• IP Address: Sets the static IP address. (Default: 0.0.0.0, available when L2TP

Network Mode is set to static IP.)

• Subnet Mask: Sets the static IP subnet mask. (Default: 255.255.255.0, available

when L2TP Network Mode is set to static IP.)

• Default Gateway: The IP address of the gateway router for the wireless AP/

Router, which is used if the requested destination address is not on the local

subnet.

• L2TP Username: Sets the L2TP user name for the WAN port.

(Default: L2TP_USERNAME; Range: 1~32 characters)

• L2TP Password: Sets a L2TP password for the WAN port. (Default:

L2TP_PASSWORD; Range: 1~32 characters)

Bigpond

Enables the settings of Telstra Bigpond network service in Australia.

Figure 4-15. Setup Wizard - WAN Bigpond

• Bigpond Username: Sets the Bigpond user name for the WAN port.

(Default: BIGPOND_USERNAME; Range: 1~32 characters)

• Bigpond Password: Sets a Bigpond password for the WAN port. (Default:

BIGPOND_USERNAME; Range: 1~32 characters)

• Bigpond Authentication Server: Specifies a Bigpond authentication server.

(Default: sm-server)