User guide

Introduction

1-6

Reset Button

The Reset button can be used to restart the wireless AP/Router or restore the

factory default configuration. If you press the button for less than 5 seconds, the

wireless AP/Router

will restart. If you press and hold down the button for 5 seconds

or more, any configuration changes you may have made are removed and the

wireless AP/Router

is restored to its factory default configuration.

WPS Button

Use the WPS button on the wireless AP/Router to automatically connect devices to

the network. Within two minutes, press the physical or virtual button on a single

wireless client device to enable it to join the WLAN.

The WPS configuration process may be initiated on any device. Only one client

device can connect with the wireless AP/Router after the WPS button is pressed.

There is no restriction to the order in which buttons are pressed.

Note: Any WPS-compatible devices could unintentionally join the WLAN if they are

within range during the two-minute set up period after the WPS button is pressed.

Note that only one device at a time can join the network when using the WPS

button.