User Manual

3 | Getting Started…
Warning:
• Network cards are sensitive to static electricity. To protect the card, avoid touching its
electrical components and always touch the metal chassis of your computer before
handling the card
1. Turn on your computer and insert the Driver, Utility, and Documentation CD. Run
the EZ Installation Wizard software and then shut down your machine.
2. Turn off your computer, unplug the power cord and remove the computer’s
cover.
3. Choose a free PCI expansion slot and remove the protective bracket if necessary.
4. Insert the adapter into the slot and make sure it is firmly seated.
5. Secure the adapter bracket into place with the screw.
6. Replace the computer’s cover.
7. Connect the EZ PCI Card 10/100 directly to your switch, hub or cable/dsl modem
using UTP cable (Category 3, 4 or 5 for 10BASE-T; Category 5 for 100BASE-TX).
The maximum allowable length of UTP cable connections is 100 meters (328ft).
When inserting an RJ-45 plug, be sure the tab on the plug clicks into position to
ensure that it is properly seated.