User Manual

Step 3: Go to the [Driver] tab and click [Update Driver]. Select the [Install from a list...] option
and click [N
ext >]. Select the [Don't Search] option and click [Next >].
Click [Have Disk] and browse to the location of the drivers on the CD. This should be
?:\SMC1244\WINXP. (Note: The ? equals the letter of your CD-ROM drive. In most cases, this is
D.) Then click [OK].
Step 4: The correct model of your SMC adapter will now be displayed. Click [N
ext >]. This
process will be completed once the drivers are copied to the hard drive and installed. Please click
[Finish] to exit the wizard.
6 | Driver Verification
Windows 95/98/Me/NT/2000/XP
Section 6.1 | Windows 95/98/Me
Step 1: Right-click the My Computer icon on your desktop and click [Pr
operties].
Step 2: Then go to the [Device Manager] tab and open the [Network adapters] section. You
should see your SMC EZ Card 10/100 in this menu. Highlight it and click [Pr
operties].
Step 3: The Device Status shows that the "This device is working properly". If there are any
error messages displayed here, you will need to click the SMC adapter and click [Remove]. Then
reboot the machine and go through the installation process again.
Section 6.2 | Windows NT
Step 1: Right-click the [Network] icon on your desktop and click [Properties].
Step 2: Verify that the SMC1244 adapter is listed in the [Adapters] section.
Step 3: Click [Start], click [Run] and type "eventvwr". This will bring up the entire System Log in
the Event Viewer. Make sure that there are no error messages regarding initializing the SMC
adapter.
Step 4: Open your NT Diagnostics utility and make sure that the SMC adapter is listed. It will
show up as "FASTNIC_".
Section 6.3 | Windows 2000
Step 1: Right-click the My Computer icon on your desktop and click [Properties].
Step 2: Then go to the Hardware tab and click [D
evice Manager]. Open the [Network adapters]
section. You should see your SMC EZ Card 10/100 card in this menu. Right-click your adapter and
click [Properties].