User Manual

Step 2: Insert the Driver CD and select the [Search for a suitable driver...] option. Then click
[N
ext >].
Step 3: Clear all checkboxes except for [S
pecify a location]. Then click [Next >].
Figure 5.9
Step 4: You will then be prompted to enter the location of the drivers. This should be
?:\SMC1244\WIN2000. (Note: The ? equals the letter of your CD-ROM drive. In most cases, this
is D.) Then click [OK]. You can also click [B
rowse] and browse to the location of the drivers on
the CD for further verification.
Step 5: The system should find the drivers. Click the [N
ext >] button to continue the installation.
(Note: If the system could not find the drivers, click the [< Back] button, and select the [Display
a list of the known drivers...] option. Select [Network Adapters] from the list of devices, press
[Have Disk] and once again browse to the location of the drivers)
Step 6: You have now completed the driver installation. Click [Finish] to initialize the adapter.
Section 5.5 | Windows XP
Step 1: After you have inserted the SMC1244TX PCI Card in your machine and turned it back on,
the Operating System will automatically recognize and install the adapter using the drivers built-
into Windows XP. If you wish to upgrade to the latest drivers available on the CD-ROM, please
continue and read the directions below.
Step 2: Click [Start] and click [Control Panel]. Then click the [Performance and Maintenance]
icon and select [System]. Click the [Hardware] tab and click [Device Manager]. Then double-click
the ethernet adapter. (Note: If the adapter was not installed properly, you may see "PCI Ethernet
Controller" instead. Double-click on that device.)