User Manual

Step 5: You will then be given the option to choose the [Media Type] for the adapter. This is
also commonly known as the Link Speed. We recommend leaving this value at [AutoSense]. This
card will automatically link up to your switch or hub at the highest supported speed. If your
switch/hub does not support auto-negotiation, please select the desired "Media Type".
(Note: If you are unsure of this value, please set it to [AutoSense])
Step 6: The system will commence binding the necessary protocols to the adapter. Click the
[Close] button.
Figure 5.8
Step 7: You will then be prompted to choose between using DHCP or assigning the card a Static
IP address. If you have a DHCP server on your network or if you plan on implementing this card
with a Cable/DSL modem, please choose the [Obtain an IP address..] option. If you have a Static
IP, please enter them now. Remember to go to the DNS tab and enter your DNS addresses as
well. Then click [OK] to continue.
Step 8: You have now completed the driver installation. Click [Yes] to restart and initialize the
adapter.
Section 5.4 | Windows 2000
Step 1: After you have inserted the SMC1244TX PCI Card in your machine and turned it back on,
the Operating System will automatically recognize the adapter and prompt you for the
appropriate drivers. Click the [N
ext >] button to begin the installation.