Safety Instructions

# Dummy remote
The dummy remote can register a "Dummy area" in the I/O map. A remote can be added without
changing the I/O map by registering the remote to the "Dummy area" even after system construction.
The remote allocation order to the I/O map is from the smallest channel to the largest channel
registered by the wireless channel which has been set during remote.
At the time, the wireless channel in which no remote is registered will be ignored.
When adding a new remote, it may be required to change the I/O map depending on the wireless
channel number.
The dummy remote can be registered only with the base unit.
# Dummy remote
(1) Change of operation mode of the base
Enable the pairing setting of the remote registration of the base and reflect the change by
clicking Reset module or by re-supplying power. Then, update the contents on the screen by
clicking the Refresh button.
(2) Inputs / outputs setting of dummy remote
Set the number of inputs and outputs of the dummy remote.
(3) Allocation of the dummy remote to the required wireless channel
Select the required wireless channel and click Insert so that the set dummy remote is displayed
in the box for "Registered remotes".
(Dummy remote registration is not complete at this point. The status is "Waiting for registration".)
(4) Determination of dummy remote registration information
Click the Save reg-info to reflect the registered information.
(When registration has been completed successfully, the status of the dummy remote will change
to "registered".)
Now, the registration procedure for the dummy remote is complete.
- To reserve the dummy remote registration, it is necessary to set the number of inputs / outputs.
If a remote with inputs / outputs which are different from the set numbers is registered, the I/O
map should be changed.