Safety Instructions

Setting and Adjustment
■Flow chart for using the wireless system
Step 1 Preparation before use (PC, Application)
(1) Install the NFC reader, writer and driver
(2) Install the I/O configurator
Step 2 Setting / installation of the wireless unit
(1) Parameter setting of “Remote” (optional)
*: Refer to the Remote Parameter Details (page XX to XX)
(2) Set the number of occupied I/O points for the module and each parameter
of the "base".
*: Different from the I/O points of the whole system.
(3) “Base” system settings
(4) Register the remote to the base (pairing)
※: The base and remote need to be powered.
(5) Assemble the I/O unit (wireless base)
(6) Installation and wiring
(7) Ethernet setting (wireless base)
*: Refer to the operation manual of the base for details.
Step 3 Connection to PLC
Note) Refer to the operation manual of the PLC manufacturer for connection to PLC and Configurator.
With the above settings, it is possible to control the upper level controller.
Refer to the operation manual for each manufacturer for how to set the controller and the PLC.
Refer to the operation manual for the I/O Configurator (NFC version) for details of the SMC wireless system
I/O Configurator.