Safety Instructions

○EX600-WDXA1
No. Name Application
1 Area close to NFC antenna
This area is in close contact with the NFC reader / writer.
"O" is the center of the NFC antenna.
2 Status LED LED display to indicate the unit status.
3
Screw hole for mounting
(M5 x 4)
Used for installing sheet metals.
4
FG terminal
※
1
To be connected to Ground (for better noise immunity).
5 Power supply cable Connect the power supply for control.
6 Input cable (E/F) Connect the input equipment (M12 connector)
7 Input cable (C/D) Connect the input equipment (M12 connector)
8 Input cable (A/B) Connect the input equipment (M12 connector)
9 Input cable (8/9) Connect the input equipment (M12 connector)
10 Input cable (6/7) Connect the input equipment (M12 connector)
11 Input cable (4/5) Connect the input equipment (M12 connector)
12 Input cable (2/3) Connect the input equipment (M12 connector)
13 Input cable (0/1) Connect the input equipment (M12 connector)
14 Pairing cable Pressed when switching to pairing mode.
15 Short jumper
Connect the jumper connector in normal use, and disconnect the jumper
connector when pairing.
*1: Grounding should be as close as possible to the product and the grounding wire should be as short as possible.
*2:Attaching the waterproof cap (EX9-AWTS: not included) to any unused connector can satisfy the enclosure requirement.