Datasheet

How to Order
PF2A20
Nil
4C
Option 2 (Refer to page 35.)
None
Sensor connector (4 pc.)
Nil
M
Unit specification
With unit switching function
Fixed SI unit
Note)
0
1
Output specification
NPN4 outputs
PNP4 outputs
Nil
A
B
Option 1 (Refer to page 35.)
None
Panel mounting
Front protective cover + Panel mounting
4-channel Flow Monitor
Remote Type
Display Unit
0 M
Note 1) Fixed SI unit [l/min or l] will be set for switch types without the unit switching function. (“-M” is suffixed at the end of part number.) Accumulated flow is reset when the
power supply turns OFF.
Note 2) Flow rate display can be switched between the basic condition of 0°C, 101.3 kPa and the standard condition (ANR) of 20°C, 101.3 kPa, and 65% RH.
Note 3) If Vcc side on sensor input connector part is short-circuited with the 0V side, the flow monitor inside will be damaged.
Note 4) Switch output and accumulated pulse output can be selected during initial setting.
Note 5) The system accuracy when combined with an applicable flow sensor.
Note 6) This product conforms to the CE mark.
0.5 to 10.5 l/min
0.5 to 10.5
l/min
0.1
l/min
l/min, CFM x 10
-2
l, ft
3
x 10
-2
0 to 999999 l, 0 to 999999 ft
3
x 10
-2
24 VDC (ripple ±10% or less) (With power supply polarity protection)
55 mA or less (Not including the current consumption of the sensor)
Same as [Power supply voltage]
Max. 110 mA (However, the total current for the 4 inputs is 440 mA maximum or less.)
1 to 5 VDC (Input impedance: Approx. 800K
Ω)
4 inputs
Excess voltage protection
NPN open collector or PNP open collector (same as switch output)
4 outputs (1 output per 1 sensor input)
With short circuit protection
Hysteresis mode: Variable (can be set from 0), Window comparator mode: Fixed (3-digits)
1s or less
±5% F.S. or less
±3% F.S. or less
±2% F.S. or less (0 to 50°C, based on 25°C)
Illuminates when output is ON OUT1: Red
IP65 for the front face only, and IP40 for the remaining parts.
Operating: 0 to 50°C, Stored: –10 to 60°C (with no freezing and condensation)
Operating or Stored: 35 to 85%RH (with no condensation)
10 to 500 Hz with a 1.5 mm amplitude or 98 m/s
2
acceleration, in each X, Y, Z direction for 2 hrs, whichever is smaller. (de-energized)
980 m/s
2
in X, Y, Z directions 3 times each (de-energized)
500 Vp-p, Pulse width 1 µs, Rise time 1 ns
Power supply / Output connection: 8P connector, Sensor connection: 4P connector (e-con)
Housing: PBT, Display: PET, Backside rubber: CR
60 g (Except for any accessories that are shipped together)
For measured value display: 4-digits, 7-segment LED (Orange)
For channel display: 1-digit, 7-segment LED (Red)
l/min, CFM x 10
-1
l, ft
3
x 10
-1
0 to 999999 l, 0 to 999999 ft
3
x 10
-1
0.1 l/pulse
PF2A510--1
2.5 to 52.5 l/min
2.5 to 52.5
l/min
0.5
l/min
0.5
l/pulse
PF2A550--1
5 to 105 l/min
5 to 105
l/min
1
l/min
1
l/pulse
PF2A511--1
PF2A200/201
10 to 210 l/min
10 to 210
l/min
2
l/min
2
l/pulse
PF2A521--1
25 to 525 l/min
25 to 525
l/min
5
l/min
5
l/pulse
PF2A551--1
Model
Applicable flow rate sensor
Flow rate measurement range
Note 1)
Set flow rate range
Note 1)
Minimum set unit
Note 1)
Accumulated flow range
Note 1)
Power supply voltage
Current consumption
Power supply voltage for sensor
Power supply current for sensor
Note 3)
Sensor input
Output
Note 4)
specifications
Hysteresis
Response time
Note 5)
Linearity
Note 5)
Repeatability
Note 5)
Temperature characteristics
Display method
Status LED’s
Resistance
Connection
Material
Weight
Enclosure
Operating temperature range
Operating humidity range
Vibration resistance
Impact resistance
Noise resistance
No. of inputs
Input protection
Switch output
(Real-time switch output,
Accumulated switch
output)
Accumulated pulse output
No. of outputs
Output protection
Display units
Real-time flow rate
Accumulated flow
Accumulated pulse flow rate exchange
value (Pulse width: 50 ms)
Note 1)
4
NPN open collector (PF2A200)
Maximum load current: 80 mA
Internal voltage drop: 1 V or less (with load current of 80 mA)
Maximum applied voltage: 30 V
Maximum load current: 80 mA
Internal voltage drop: 1 V or less (with load current of 80 mA)
PNP open collector (PF2A201)
Accessory / Power supply output cable (2 m)
Connectable remote type sensor part is PF2A5--1 (with analog output 1 to 5 V).
Digital Flow Switch Series PF2A
For Air
Note) Fixed units:
Real-time flow rate:
l/min
Accumulated flow:
l
Specifications
Note 1, 2)