Datasheet

Face seal
Applicable Tubing
Tubing material FEP, PFA, Nylon, Soft nylon, Polyurethane
Tubing O.D. Ø 1/8", Ø 3/16"
Specifications
Fluid
Air, Water
∗
1
Operating pressure range
∗
2
-100 kPa to 1 MPa
Proof pressure (at 23 °C)
3 MPa
Ambient and fluid temperature
-5 to 60 °C, Water: 0 to 40 °C
(No freezing)
Thread
Mounting section
JIS B0203 (Taper thread for piping)
JIS B0205 (Metric coarse thread)
Nut section
JIS B0205 (Metric fine thread)
Sealant on the threads
Seal ring
∗1 The surge pressure must be under the maximum operating pressure.
∗2 Do not use the fittings with a leak tester or for vacuum retention because they are not guaranteed for zero
leakage.
Principal Parts Material
Body C3604, PBT
Stud C3604 (Thread portion)
Chuck Stainless steel 304
Guide Stainless steel 304
Release button POM
Seal, O-ring, Seal ring NBR
Suitable for use with nylon and
urethane. Large retaining force.
The chuck provides secure retention and
the collet increases the holding force on
the tube.
Can be used for a wide range of
pressures from a low vacuum
up to a pressure of 1 MPa.
The use of a special profile ensures
sealing and reduces resistance when
the tube is inserted.
Requires little force for
removal.
Releases the chuck collet to remove
the tube as well as to prevent the
chuck from biting too deeply into the
tubing.
Effective when piping in a
confined space.
Body part rotates allowing for
positioning.
Face seal method
Seal
Stud
Release button
O-ring
Body
Piping installability is improved by changing
to the face seal structure.
Seal ring
Chuck
Guide
One-touch IN/OUT
connection.
Possible to use in
vacuum to -100 kPa.
Drastically reduces
screw-in time with the
face seal method.
R
Connection thread
Inch Size One-touch Fittings
Applicable Tubing: Inch Size, Connection Thread: R
KQ2 Series
Oval Type
81