Datasheet
Back page 1
Series IZS31
Safety Instructions
Note 1) ISO 4414 : Pneumatic fluid power --General rules relating to systems
Note 2) JIS B 8370: General Rules for Pneumatic Equipment
Warning
Caution :
Operator error could result in injury or equipment damage.
Warning
:
Operator error could result in serious injury or loss of life.
Danger :
In extreme conditions, there is a possible result of serious injury or loss of life.
These safety instructions are intended to prevent a hazardous situation and/or
equipment damage. These instructions indicate the level of potential hazard by a
label of “Caution”, “Warning” or “Danger”. To ensure safety, be sure to observe
ISO 4414
Note 1)
,
JIS B 8370
Note 2)
and other safety practices.
1. The compatibility of pneumatic equipment is the responsibility of the person
who designs the pneumatic system or decides its specifications.
Since the products specified here are used in various operating conditions, their compatibility for the
specific pneumatic system must be based on specifications, or post analysis and/or tests to meet the
specific requirements. The expected performance and safety assurance will be the responsibility of the
person who has determined the compatibility of the system. This person should continuously review the
suitability of all items specified, referring to the latest catalogue information with a view to giving due
consideration to any possibility of equipment failure when configuring a system.
2. Only trained personnel should operate pneumatically operated machinery and
equipment.
Since the product generates a high voltage, handling it incorrectly can be dangerous. Assembly,
handling, and repair of pneumatics systems should be performed only by trained and experienced
operators.
3. Do not service the machinery/equipment or attempt to remove components
until safety is confirmed.
1. Inspection and maintenance of the machinery/equipment should only be performed after confirming that
safety precautions such as grounding, electric shock prevention, and various other types of damage
prevention have been taken.
2. When equipment is to be removed, confirm the safety process as mentioned above. Turn off the supply
pressure for this equipment and exhaust all residual compressed air in the system.
3. Before the machinery/equipment is restarted, take measures to prevent short circuiting and other such
electical failures.
4. Avoid using the product in the following conditions or environment. However,
if the product must be used in these conditions, please contact SMC first and
be sure to take all necessary safety precautions.
1. Conditions and environments beyond the given specifications, or if product is used outdoors.
2. Installation on equipment in conjunction with atomic energy, railway, air navigation, vehicles, medical
equipment, food and beverages, recreation equipment, emergency stop circuits, clutch and brake circuits
in press applications, or safety equipment.
3. An application which has the possibility of having negative effects on people, property, requiring special
safety analysis.