Datasheet
15
Determining the Model and Settings 2 / Pulse DC Mode
6) Wiring of power supply cable
· Connect the dedicated power supply cable.
Connection with ionizer driving power supply
Symbol Cable colour
—
Ionizer driving power supply cable
—
Description
Connection needs
Contents
5) Frequency selection switch setting
·
Selects ion generation frequency
Ion generation frequency
Switch setting
1 Hz
3 Hz
5 Hz
10 Hz
15 Hz
20 Hz
30 Hz
60 Hz
0
1
2
3
4
5
6
7
DC1 (+)
DC1 (–)
OUT4
Power supply 24 VDC
Power supply GND [FG]
Sensor monitor output
Brown
Blue
Dark green
∗
DC1 (–) [Blue] is sure to groung it according to class-D. If the terminal is not grounded, the ionizer may malfunction.
GND
Wiring of input/output signal power suply cable
Class-D ground
DC power supply
Blue
Brown
Symbol Cable colour
DC2 (+)
DC2 (–)
IN1
IN2
—
—
OUT1
OUT2
OUT3
Red
Black
Light green
Gray
White
Orange
Pink
Yellow
Purple
—
—
Power supply 24 VDC
Power supply GND
Discharge
stop signal
Maintenance start signal
—
—
Maintenance output signal
Irregular signal
—
—
Description
Connection needs
Contents
: Minimum wiring requirement for ionizer operation
: Wiring necessary to use various functions
—: Wiring not required in the sensing DC mode. Exercise caution to ensure that this wire does not short-circuit to other wires.
7) Air piping
· For single-side piping, block the unused port with the M-5P plug supplied with the ionizer.
Static electricity removal
completion signal
Input/output signal power supply cable
Signal to be input when determining the necessity of electrode needle maintenance
Signal to be output when the workpiece’s electrostatic potential is outside ±30 V or
when electrode needle contamination is being detected.
Signal to be output when electrode needle maintenance is necessary.
Outputs signal when there is irregular high voltage, irregular sensor, irregular CPU (B type contact output)
Signal for enabling/disabling discharging
(NPN specification) Discharging is enabled when connected to DC2 (–) [Black].
(PNP specification) Discharging is enabled when connected to DC2 (+) [Red].
+24 VDC
Ionizer Series IZS31