Datasheet

9
Functions
When a maintenance start signal is input, the ionizer detects any deterioration that may interfere with the electrode needles’ capability to
remove static electricity. If the needles need to be cleaned due to such deterioration, a maintenance display LED comes on and the
ionizer outputs a maintenance output signal.
Note) Deterioration in static electricity removal capability cannot be detected by only connecting a feedback sensor or autobalance sensor.
Verify the capability by periodically inputting a maintenance start signal.
2. Dirt-detection on an electrode needle
3. Display/Setting component description
No. Description
Power supply display
Sensor display
Negative display
Static electricity removal completion display
Positive display
Irregular high voltage display
Irregular sensor display
Maintenance display
Maintenance level selection switch
Frequency selection switch
Ion balance adjustment trimmer
LED (Green)
LED (Green)
LED (Blue)
LED (Green)
LED (Orange)
LED (Red)
LED (Red)
LED (Red)
Illuminates when power is supplied. Blinks when the supply voltage is abnormal.
Illuminates when the feedback sensor or autobalance sensor is connected.
Illuminates when an abnormal current flows through an electrode needle.
Illuminates when electrode needle contamination is detected. Blinks while the contamination is being detected.
Used to adjust the ion balance when the autobalance sensor is not used.
Functionality differs depending on the operation mode.
Refer to Section 4, “Determining the Model and Settings” on page 10.
Type Contents
1
2
3
4
5
6
7
8
9
10
11
Illuminates when the feedback sensor or autobalance sensor is not operating normally.
Functionality differs depending on the operation mode.
Refer to Section 4, “Determining the Model and Settings” on page 10.
!1 !0 o iuy tre wq
Ionizer Series IZS31
Rotary switch
Rotary switch
Trimmer