Installation Guide

I NSTALLING THE S WITCH
3-12
Connecting to a Power Source
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC receptacle located at
the back of the switch.
Figure 3-7 Power Receptacles
2. Plug the other end of the cable into a grounded, 3-pin, AC power
source.
Note: For International use, you may need to change the AC line
cord. You must use a line cord set that has been approved for
the receptacle type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the PWR LED is lit. If not, check that the power cable is correctly
plugged in.
4. If you have purchased a Redundant Power Unit, connect it to the
switch and to an AC power source now, following the instructions
included with the package
4
.
4. An RPU is not yet available for this product.
100-240V~ 50-60Hz 2A
RPU
DC
12V 4.5A