Datasheet

Auto switch mounting screw
Auto switch
Auto switch model Tightening torque
D-M9쏔(V)
D-M9쏔W(V)
D-M9쏔A(V)
0.05 to 0.15
D-A9쏔(V)
0.10 to 0.20
Type Model Electrical entry Features Applicable bore size
Solid state
D-M9NV, M9PV, M9BV
Grommet (Perpendicular)
—
Ø 32 to Ø 63
D-M9NWV, M9PWV, M9BWV
Diagnostic indication
(2-colour indication)
D-M9NAV, M9PAV, M9BAV
Water resistant
(2-colour indication)
Reed
D-A93V, A96V
—
D-A90V
Without indicator light
<Applicable Auto Switch>
Solid state switch ······ D-M9N(V)/M9P(V)/M9B(V)
D-M9NW(V)/M9PW(V)/M9BW(V)
D-M9NA(V)/M9PA(V)/M9BA(V)
Reed switch ················
D-A90(V)/A93(V)/A96(V)
How to Mount and Move the Auto Switch
Auto switch mounting screw tightening torque
[N·m]
∗ As a guide, turn 90° from the position where it comes to feel tight.
Note 1) The D-M9쏔 and A9쏔 cannot be mounted on square groove of the CP96 series.
Note 2) The D-M9쏔V/M9쏔WV/M9쏔AV/A9쏔V are mountable on Ø 32 to Ø 63.
앫Use a watchmaker’s screwdriver with a handle diameter of 5 to 6 mm when tightening the auto switch mounting screw.
How to Mount and Move the Auto Switch
∗ Normally closed (NC = b contact) solid state auto switches (D-F9G/F9H) are also available.
For details, refer to the Auto Switch Guide.
∗ With pre-wired connector is also available for solid state auto switches. For details, refer to the Auto Switch Guide.
Other than the applicable auto switches listed in “How to Order”, the following auto switches are mountable.
Refer to the Auto Switch Guide for the detailed specifi cations.
20
Auto Switch Mounting
Series CP96