Datasheet

Mounting Style and Accessory/For details, refer to page 51.
∗ Knuckle pin and retaining ring are shipped together with double knuckle joint.
Bore size (mm) 6
27
3
16
5
10
35
6
16
5
16
70
9
40
15
Mass
(g)
Mounting Bracket Part No.
Bore size (mm)
10
CJ-L010B
CJ-F010B
16
CJ-L016B
CJ-F016B
6
CJ-L006B
CJ-F006B
Be sure to read before handling.
Refer to front matters 54 and 55 for
Safety Instructions and pages 3 to 11 for
Actuator and Auto Switch Precautions.
Precautions
54
Series CJ2W
Mounting Basic style Foot style Flange style
Standard
equipment
Option
Mounting nut
Rod end nut
Single knuckle joint
Double knuckle joint
∗
Mounting bracket
Foot bracket
Flange bracket
Basic mass
∗
Additional mass per each 15 mm of stroke
Mounting bracket
mass
Foot style
Flange style
Theoretical Output
∗ Mounting nut and rod end nut are included in the
basic mass.
Calculation: (Example)
CJ2WL10-45
• Basic mass ······························ 35 (ø10)
• Additional mass ······················· 6/15 stroke
• Cylinder stroke ························· 45 stroke
• Mounting bracket mass ············ 16 (Foot style)
35 + 6/15 x 45 + 16 = 69 g
• For accessory bracket mass, refer to page 44.
Refer to “Double acting cylinder” in Theoretical
Output 1 of Technical data 3 on page 1573.
In the case of the double rod style, the force at IN
side will be its theoretical output.
Mounting
Caution
1. During installation, secure the rod cover and
tighten by applying an appropriate tightening
force to the retaining but or to the rod cover
body. If the head cover is secured or the
head cover is tightened, the cover could
rotate, leading to the deviation.
2. Tighten the retaining screws to an
appropriate tightening torque within the
range given below.
ø6: 2.1 to 2.5 N·m, ø10: 5.9 to 6.4 N·m,
ø16: 10.8 to 11.8 N·m
3. To remove and install the retaining ring for
the knuckle pin, use an appropriate pair of
pliers (tool for installing a type C retaining
ring for hole). In particular, use a pair of ultra-
mini pliers for removing and installing the
retaining rings on the ø10 cylinder.
4. In the case of auto switch rail mounting style,
do not remove the rail that is mounted.
Because retaining screws extend into the
cylinder, this could lead to an air leak.
P0015-P0124-E.qxd 08.10.2 4:00 PM Page 54