User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (Wireless Model Only)
- DDNS Screen
- Video & Audio Screen
- Video Access Screen
- User Database Screen
- Motion Detection Screen
- E-Mail Screen
- FTP Screen
- HTTP Screen
- Event Trigger Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 WindowsViewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Streaming Video/Audio Solution
Max. Frame Rate
Select the desired Maximum bandwidth for the video stream. Note
that you can specify EITHER the Bandwidth OR the Frame Rate,
not both. If the Bandwidth is defined, the frame rate will be adjusted
as necessary to achieve the specified frame rate.
The default value for bandwidth is 30.
MJPEG Settings
Resolution
Select the desired video resolution format. The default resolution is
set to 640*480.
Fixed Video
Quality
Select the desired fix quality. The default fix quality is set to Very
High.
Max. Frame Rate
Select the desired Maximum bandwidth for the video stream. Note
that you can specify EITHER the Bandwidth OR the Frame Rate,
not both. If the Bandwidth is defined, the frame rate will be adjusted
as necessary to achieve the specified frame rate.
The default value for bandwidth is 30.
Mobile Settings
Enable Mobile
Streaming
Enable streaming video for the mobile device by checking this
checkbox.
Resolution
The default resolution is set to 160x120.
Video Quality
Control
• Constant Bit Rate: Select the desired fix bit rate.
• Fixed Quality: Select the desired option. The default fix quality
is set to Normal.
Max. Frame Rate
Select the desired Maximum bandwidth for the video stream.
Access Code
Enter the 8-digit code (0~9) for accessing the live video from
camera through cell phone connection.
Video Adjustment
Power Line
Frequency
Select the power line frequency (50Hz or 60Hz) used in your region,
to improve the picture quality under florescent lighting.
White Balance
Select the desired option to match the current environment and
lighting.
Lighting Condition
Select the desired option to match the current lighting condition.
Brightness
If necessary, you can adjust the brightness to obtain a better image.
For example, if the camera is facing a bright light, the image may be
too dark. In this case, you can increase the brightness.
Sharpness
Select the desired option for the sharpness. You can select a
Sharpness value between -3 and 3.
Options
Microphone
Enable audio by checking this checkbox. Using Audio will increase
the bandwidth requirements slightly.
Audio Type
Select the desired audio type.
Speaker
Enable speaker sound by checking this checkbox.
Flip
This setting will have the image swapped top-to-bottom.
45