User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Basic Setup
- Chapter 3 Viewing Live Video
- Chapter 4 Advanced Viewing Setup
- Chapter 5 Web-based Management
- Introduction
- Connecting to Network Camera
- Welcome Screen
- Administration Menu
- System Screen
- Network Screen
- Wireless Screen (Wireless Model Only)
- DDNS Screen
- Video & Audio Screen
- Video Access Screen
- User Database Screen
- Motion Detection Screen
- E-Mail Screen
- FTP Screen
- HTTP Screen
- Event Trigger Screen
- Maintenance Screen
- Status Screen
- Log Screen
- Chapter 6 WindowsViewing/Recording Utility
- Chapter 7 Troubleshooting
- Appendix A Specifications
- Appendix B Streaming Video/Audio Solution
Security
Security System
Select the desired option, and then enter the settings for the selected
method:
• Disabled - No security is used. Anyone using the correct SSID
can connect to your network. This is default.
• WEP - The 802.11b standard. Data is encrypted before
transmission, but the encryption system is not very strong.
• WPA/WPA2 Personal - Like WEP, data is encrypted before
transmission. WPA is more secure than WEP, and should be
used if possible. WPA Personal is the version of WPA which
does NOT require a Radius Server on your LAN.
WEP
Authentication Type
Normally this can be left at the default value of "Automatic." If that
fails, select the appropriate value - "Open System" or "Shared
Key." Check your wireless card's documentation to see what
method to use.
Note: In Infrastructure mode, either setting will normally work,
since most Access Points can use both methods.
WEP Encryption
Select the WEP Encryption level:
• 64 Bit Keys (10 Hex chars)
• 128 Bit Keys (26 Hex chars)
• 64 Bit Keys (5 ASCII chars)
• 128 Bit Keys (13 ASCII chars)
Passphrase
Enter a word or group of printable characters in the Passphrase box
and click the "Generate Key" button to automatically configure the
WEP Key(s). If encryption strength is set to 64-bit, then each of the
four key fields will be populated with key values. If encryption
strength is set to 128-bit, then only the selected WEP key field will
be given a key value.
WEP Keys
• Use the radio buttons to select the default key.
• Enter the key value you wish to use. Other stations must have
the same key values.
• Keys must be entered in Hex. Hex characters are the digits (0 ~
9) and the letters A ~ F.
• Click Clear Keys to set the Keys to be blank.
WPA/WPA2 Personal
Shared Key
Enter the key value. Data is encrypted using a key derived from the
network key. Other Wireless Stations must use the same network
key. The PSK must be from 8 to 63 characters in length.
41