Switch Management Guide

C LASS OF S ERVICE C OMMANDS
33-2
priority bits
This command sets the priority bits in the VLAN tag of packets sent by
the CPU. Use the no form to restore the default value.
Syntax
[no] priority bits
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
When priority bits are used in packets sent from the CPU, they are
always set to CoS value 0. See Table 33-3, “Default CoS Priority
show priority Shows the priority bits used in packets
sent by the CPU, and the IPv6 Traffic
Class to Class-of-Service priority map
PE 33-4
show queue mode Shows the current queue mode PE 33-5
Port-based Priority Settings
switchport priority
default
Sets a port priority for incoming untagged
frames
IC 33-17
queue bandwidth Assigns round-robin weights to the
priority queues
IC 33-7
queue cos-map Assigns class-of-service values to the
priority queues
IC 33-8
show queue
bandwidth
Shows round-robin weights assigned to
the priority queues
PE 33-9
show queue cos-map Shows the class-of-service map PE 33-10
show interfaces
switchport
Displays the administrative and
operational status of an interface
PE 25-16
Table 33-2 Priority Commands (Layer 2)
Command Function Mode Page