Switch Management Guide

VDSL C OMMANDS
29-62
show lre band-plan
This command displays the frequency bands used for VDSL signals.
Syntax
show lre band-plan [unit/port]
• unit - Stack unit. (Range: 1)
• port - Port number. (Range: 1-16)
Command Mode
Privileged Exec
show lre noise-mgn Displays the targeted signal-to-noise margin
that VDSL ports must achieve to
successfully complete initialization
PE 29-74
show lre
rate-adaption
Shows if line rate adaptation which sets the
optimal transmission rate based on existing
line conditions is enabled or disabled
PE 29-75
show lre config Shows the VDSL configuration settings for
an interface
PE 29-76
show lre line-profile Displays a specified line profile which may
be applied selected VDSL ports
PE 29-77
show lre
alarm-profile
Displays a specified alarm profile which may
be applied selected VDSL ports
PE 29-78
Displaying System Status
show lre Displays the communication status of the
VDSL line
PE 29-79
show lre phys-info Displays physical layer information about
the VDSL line
PE 29-80
show lre rate-info Displays rate information for the VDSL line PE 29-81
Displaying Statistics
show lre perf Displays performance information
including common error conditions over
predefined intervals for the VDSL line
PE 29-82
Table 29-9 Commands for Displaying VDSL Information (Continued)
Command Function Mode Page