User's Manual

I NSTALLING THE S WITCH
6
Note: If an attached device does not support auto-negotiation, the data
rate will be sensed automatically and the communication mode
will default to half duplex.
4. Cascading Switches and Other Network Devices: All the ports on
the switch support automatic MDI/MDI-X configuration for cable
connections. This allows you to use straight-through cable to connect
to other switches or hubs from any port on the switch. No crossover
cables or other device settings are needed. See the “Cable
Specifications” on page 9 of this guide for further information.
Caution: Do not plug a phone jack connector into any RJ-45 port. This
may damage the switch. Instead, use only twisted-pair cables
with RJ-45 connectors that conform with FCC standards.