User's Manual

SMCWK01-Z Key Pad Quick Start Guide
Copyright
©
2010 SMC Networks Page 2
All Rights Reserved
SMCWK01-Z 08172010
8/17/10
5 Mounting the Key Pad
A. Use a Phillips screwdriver to remove
the faceplate from the front of the key
pad.
B. Behind the circuit board, find the four
holes at the back of the device.
C. Place the key pad on
the wall where you
want it located and use
a pen to mark the
location of the four
holes.
D.
E. Affix the key pad to the installed screws.
Install four screws in the locations
marked on the wall. Do not screw them
in all the way.
F. Replace the faceplate to the front of the key pad.
6 Control Buttons
With the key pad, you can arm the system (in Arm Away or
Arm Stay modes), disarm it, or send an Emergency alarm for
police assistance.
System Status
Press the System Status button to show the current status of
the security system or the device. The
button lights to
show the current status of the device and then.
¾ Lights green for 3 seconds if the system is disarmed.
¾ Lights red for 3 seconds if the system is armed.
¾ Lights orange for 3 seconds if the system is not ready to
be armed, such as when a door is open.
¾ Flashes green 3 times every 5 seconds if the key pad has
been defaulted and is ready to pair to the TouchScreen.
Arm Away
Enter a valid keypad code, then press the
button to arm
the system in Arm Away mode (no one is in the premises).
For more information about arming mode, refer to the
TouchScreen User Guide.
The
button turns red for 3 seconds to show the Exit Delay
started (default 30 seconds—TouchScreen beeps during this
period). If the system is not ready for arming, such as if a
door or window is open, the
button flashes orange 7
times.
Arm Stay
Enter a valid keypad code, then press the
button to arm
the system in Arm Stay mode (people are in the premises).
For more information about arming mode, refer to the
TouchScreen User Guide.
The
button turns red for 3 seconds to indicate the Exit
Delay started (twice as long as the period configured for Arm
Away—up to 120 seconds with no beeping from the
TouchScreen). If the system is not ready for arming, such as
when a door or window is open, the
button flashes
orange 7 times.
Disarm
Enter a valid keypad code followed by the
button to
disarm the system.
The
button turns green for 3 seconds to indicate the
system has been disarmed. There is no Entry Delay period.
Panic
Press and hold the Panic button for about 2 seconds to send
a silent alarm to central monitoring for police assistance.
The
button flashes red to indicate the alarm was sent.
The TouchScreen does not react in any way; however, the
History tab on the Security widget shows an alarm was sent.
Also, contact persons will receive email and SMS
notifications if they are configured to do so.
Sensor State
LED Display
Arming Red
Disarming Green
System Not Ready to Arm Orange

continued on next page