User's Manual

SMCWEB-N2 Wireless N Universal Repeater User Manual
- 29 -
6 Configuring SMCWEB-N2
Table 6.1 IP information of AP/Repeater/Client modes of SMCWEB-N2
Mode On
the Case
Mode Available
In the Web
Management IP
Address
Subnet MAC
Address
DHCP
Way of
connecting to
PC
AP
Bridge (default)
192.168.2.1 255.255.255.0
Disable Ethernet cable
/Wireless
Router Enable Wireless only
Repeater Wireless
Universal
Repeater
(default)
192.168.2.1 255.255.255.0
Disable Ethernet cable
/Wireless
WDS
Client Client (default) 192.168.2.1
255.255.255.0
Disable Ethernet cable
only
Step 1 Set the three-way switch on the case of SMCWEB-N2 to the mode you
want.
Run the Internet Explorer (IE). Enter the management IP address of
192.168.2.1 and press Enter. In the login window that is displayed, enter
the user name admin and password smcadmin, and click Login.
Step 2 Configure parameters for the mode you selected. Terminal devices can
access the network through SMCWEB-N2 after you finish configuration
by following procedures in the sections below.