User's Manual

HAPTER

| Introduction

Rear Panel

– 27 –

WPS BUTTON Push this button to start WPS authentication of a wireless device. Push and

hold down this button for more than 5 seconds to reset the unit.

OTE

After a device is successfully added to the network by WPS, the WPS

LED will remain on for about 5 minutes and then turn off. When press and

hold the WPS Button for more than 5 seconds, you will reset the router.

REAR PANEL

Figure 2: Rear Panel

The following items are located on the rear panel (from left to right).

WIRELESS ANTENNAS Receives and transmits wireless data.

POWER The Power socket is where you connect the power adapter. Use the power

adapter provided with the Router.

WAN

LAN (1-4)

On There is a device linked to the corresponding port, but

there is no activity.

Blinking There is an active device linked to the corresponding

port.

Off There is no device linked to the corresponding port.

WPS On A wireless device has been successfully added to the

network by WPS. The LED will remain on for about 5

minutes.

Slow Blinking A wireless device is connecting to the network by

WPS. This process lasts for about 2 minutes.

Off WPS is not in progress.

Table 2: LED Behavior (Continued)

LED Status Description