User's Manual

SMC Wireless Siren ZigBee Range Extender Guide
Copyright
©
2012 SMC Networks Page 4
All Rights Reserved
I/M SMCSRXX-Z rev. 2.2
6/20/2012
B. Connect the battery to the battery connector
by inserting the battery plug into the pins so
that the wire colors are arranged as shown in
the picture below.
C. The Status LED flashes green when the
battery is connected. This means that the
device is ready to be added to a
Touchscreen.
Note: If the Status LED does not flash green, the
device may not be defaulted. To default the
sensor, remove the battery from the connector.
Then press the tamper switch button while
inserting the battery plug into the pins, as shown in
the figure above. Release the tamper switch as
soon as the LED flashes (this is important). Confirm
that the Status LED is flashing green to show the
siren is ready to be added to a Touchscreen.
D. Replace the battery cover and the battery
cover screw.
9 Adding the Siren
A. At the Touchscreen Home screen, tap the
Settings app.
B. On the Settings screen, use the keypad to
enter the Installer Code.
C. On the Technician Code/Id screen, enter
your Technician ID and tap Done.
D. On the Settings menu, select Home Devices
> Sirens > Add Siren. The Locating Sirens
screen appears.
E. Tap Next. The system scans the premises for
sirens that can be added. Sirens must be
defaulted and not currently paired with
another Touchscreen.
F. When the Touchscreen finds a siren, tap the
tamper switch to pair it.
Note: If the Touchscreen cannot find the device,
reset the siren to factory default: Disconnect the
battery and press the tamper switch while
reconnecting the battery. Release the tamper
switch as soon as the LED flashes (this is
important).
G. Follow the system prompts to complete the
add process and to configure the device. The
device is ready to be installed.
10 Installation Instructions
A. CA version: Plug the Siren Repeater into a
wall. The outlet must be connected to AC
mains power at all times and must not be
controlled by a light switch.
B. NA version: Remove the existing electrical
outlet cover screw and use the supplied
electrical outlet cover screw. This screw is
longer than the one securing the battery
cover. Plug the device into the BOTTOM plug
of the wall outlet. Replace the center screw
through the hole in the electrical outlet
mounting tab. Tighten the screw. Use the
supplied leveling washers and/or rubber pads
to confirm the tamper switch is pressed
properly against wall.
continued on next page