USER GUIDE EZ SwitchTM 10/100/1000 8-Port Gigabit Ethernet Switch SMCGS805
EZ SwitchTM 10/100/1000 User Guide From SMC’s EZ line of low-cost workgroup LAN solutions No. 1, Creation Road III, Hsinchu Science Park, 30077, Taiwan, R.O.C.
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. Copyright © 2014 by SMC Networks, Inc. No.
WARRANTY AND PRODUCT REGISTRATION To register SMC products and to review the detailed warranty statement, please refer to the Support Section of the SMC Website at http://www.smc.com.
COMPLIANCES AND SAFETY STATEMENTS FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
COMPLIANCES AND SAFETY STATEMENTS This information technology equipment complies with the requirements of the Council Directive 2004/108/EC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility and 2006/95/EC for electrical equipment used within certain voltage limits and the Amendment Directive 2006/95/EC.
COMPLIANCES AND SAFETY STATEMENTS LVD: ◆ EN 60950-1:2006+A11:2009+A1:2010 + A12:2011 CE MARK WARNING This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 class A for ITE, the essential protection requirement of Council Directive 2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility.
COMPLIANCES AND SAFETY STATEMENTS ◆ 為避免發生電氣短路情形,請務必將所有沒用到的螺絲、迴紋針及其他零件收好,不要 遺留在主機板上或產品主機中。 ◆ 灰塵、溼氣以及劇烈的溫度變化都會影響主機板的使用壽命,因此請盡量避免放置在這 些地方。 ◆ 請勿將產品主機放置在容易搖晃的地方。 ◆ 若在本產品的使用上有任何的技術性問題,請和經過檢定或有經驗的技術人員聯絡。 使用注意事項 ◆ 在您開始操作本系統之前,請務必詳閱以下注意事項,以避免因為人為的疏失造成系統 損傷甚至人體本身的安全。 ◆ 使用前,請檢查產品各部份組件是否正常,以及電源線是否有任破損,或是連接不正確 的情形發生。 ◆ 如果有任何破損情形,請盡速與您的授權經銷商連絡,更換良好的線路。 ◆ 產品放置的位置請遠離灰塵過多,溫度過高,太陽直射的地方。 ◆ 保持機器在乾燥的環境下使用,雨水、溼氣、液體等含有礦物質將會腐蝕電子線路。 ◆ 使用時,請務必保持周遭散熱空間,以利散熱。 ◆ 使用前,請檢查各項周邊設備是否都已經連接妥當再開機。 ◆ 避免邊吃東西邊使用,以免污染機件造成故
COMPLIANCES ◆ AND SAFETY STATEMENTS 產品的機殼、鐵片大部份都經過防割傷處理,但是您仍必須注意避免被某些細部鐵片尖 端及邊緣割傷,拆裝機殼時最好能夠戴上手套。 當你有一陣子不使用產品時,休假或是颱風天,請關閉電源之後將電源線拔掉。 – 9 –
ABOUT THIS GUIDE PURPOSE This guide details the hardware features of the switch, including the physical and performance-related characteristics, and how to install the switch. AUDIENCE The guide is intended for use by network administrators who are responsible for installing and setting up network equipment; consequently, it assumes a basic working knowledge of LANs (Local Area Networks).
CONTENTS 1 2 A WARRANTY AND PRODUCT REGISTRATION 4 COMPLIANCES AND SAFETY STATEMENTS 5 ABOUT THIS GUIDE 10 CONTENTS 11 INTRODUCTION 13 Overview 13 Package Contents 13 Features 14 IEEE 802.
CONTENTS Physical Characteristics – 12 – 23
1 INTRODUCTION OVERVIEW The EZ Switch 10/100/1000, SMCGS805, is a powerful, high-performance Gigabit Ethernet switch with eight RJ-45 ports. The switch supports autonegotiation on all ports, which means they automatically negotiate with connected partners to determine the network speed (10/100/1000 Mbps) and duplex mode (full or half duplex). The auto-sensing ability of the ports provides an easy way to migrate from 10/ 100 Mbps to a 1000 Mbps network.
CHAPTER 1 | Introduction Package Contents ◆ SMC Warranty Card FEATURES ◆ Complies with 10BASE-T specifications of the IEEE 802.3 standard ◆ Complies with 100BASE-TX specifications of the IEEE 802.3u standard ◆ Complies with 1000BASE-T specifications of the IEEE 802.3ab standard ◆ 8 10/100/1000 Mbps RJ-45 ports ◆ Supports MDI/MDI-X auto crossover ◆ Supports full- and half-duplex operation on all ports ◆ Supports back-pressure (half duplex) and full-duplex flow control (IEEE 802.
CHAPTER 1 | Introduction Package Contents IEEE 802.1P QOS The SMCGS805 switch supports 802.1p priority queuing Quality of Service, which is an implementation of the IEEE 802.1p standard. With the 802.1p QoS function, you can reserve bandwidth for important functions that require a lot of bandwidth or have a high priority, such as VoIP (Voice-over Internet Protocol), web browsing applications, or video conferencing.
CHAPTER 1 | Introduction Package Contents LOOPBACK DETECTION AND PREVENTION When a loop occurs at a port, the switch will ■ Block the loop port, automatically protecting the switch. ■ Flash the port LED twice every second. ■ Turn the Loop LED on red. When the loop clears the port LED will cease flashing and the Loop LED will turn off.
CHAPTER 1 | Introduction Package Contents PRIVATE VLAN SUPPORT The switch is designed for Internet access deployment where subscriber end nodes are connected to an Internet Service Provider network through the switch. In this application, each port is isolated in its own private VLAN to provide security for each end user, only the uplink port (Port 1) can communicate with all other ports. Ports 2-8 cannot communicate with each other.
2 HARDWARE DESCRIPTION PORT AND SYSTEM STATUS LEDS The switch contains one power LED, one loop LED for the device, and Link/Act LEDs for each port. Refer to the following table for LED definitions: Figure 4: Front Panels Table 1: System and Port Status LEDs LED Condition Status PWR On Green The internal power supply is operating normally. Off The unit has no power connected. On Red The switch has detected a loop condition and disabled the appropriate port.
CHAPTER 2 | Hardware Description Installation Table 1: System and Port Status LEDs (Continued) LED Condition Status Link/Act (1000M) On Amber Port has established a valid 1000 Mbps network connection. Flashing indicates activity. Flashing Amber Flashing indicates activity. Off There is no valid link on the port. INSTALLATION When installing the switch, follow these guidelines: ◆ Place the switch in an appropriate ventilated environment. A minimum of 25 mm space around the unit is recommended.
CHAPTER 2 | Hardware Description Installation For cable selection, refer to the following table. Table 2: Cable Types Network Speed Cable Type Max. Length 10 Mbps Cat. 3, 4, 5 UTP/STP 100 meters 100 Mbps Cat. 5 UTP/STP 100 meters 1000 Mbps Cat.
A TROUBLESHOOTING DIAGNOSING SWITCH INDICATORS THE PWR LED IS OFF ◆ Make sure the AC power cord is connected to the switch and power source properly. ◆ Make sure the power source is ON. THE LINK/ACT LED IS OFF WHEN A DEVICE IS CONNECTED TO THE CORRESPONDING PORT ◆ Make sure that the cable connectors are firmly plugged into the switch and the device. ◆ Make sure the connected device is turned on and working properly. ◆ The cable must be less than 100 meters long (328 feet).
APPENDIX A | Troubleshooting Installation INSTALLATION Verify that all system components have been properly installed. If one or more components appear to be malfunctioning (such as the power cord or network cabling), test them in an alternate environment where you are sure that all the other components are functioning properly.
B SPECIFICATIONS PHYSICAL CHARACTERISTICS STANDARDS IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3ab 1000BASE-T IEEE 802.3x full-duplex flow control IEEE 802.3az Energy-Efficient Ethernet IEEE 802.1p QoS INTERFACE 8 10/100/1000BASE-T RJ-45 ports NETWORK DATA RATE 10/100/1000 Mbps Auto-negotiating TRANSMISSION MODE 10/100 Mbps: Full-duplex, Half-duplex 1000 Mbps: Full-duplex SWITCHING 16 Gbps CAPACITY THROUGHPUT 11.
APPENDIX B | Specifications Physical Characteristics POWER SAVING Up to 75% power paving BUFFER MEMORY 128K bytes MAC ADDRESS TABLE 8K JUMBO FRAME 9K bytes TEMPERATURE Operating: 0 °C to 45 °C (32 °F to 112 °F) HUMIDITY Operating: 10% to 90% (non-condensing) LED INDICATIONS System: PWR/LOOP Ports: Link/Act POWER SUPPLY External power adapter 5V/1A DIMENSIONS 140.0 x 77.0 x 27.0 mm (5.51 x 3.07 x 1.06 in.) WEIGHT 275 g (0.
APPENDIX B | Specifications Physical Characteristics EMISSIONS FCC, CE – 25 –
Headquarters No. 1, Creation Rd. III Hsinchu Science Park Taiwan 30077 Tel: +886 3 563 8888 Fax: +886 3 668 6111 Singapore 15 Enggor Street #10-04, Realty Centre Singapore 079716 Tel: +65-63387667 Fax: +65-63387767 su www.smc.com www.smc-asis.com www.smcnetworks.co.kr Declaration of Conformity (DoC) can be obtained from www.smc.com -> support -> download SMCGS805 www.smc.com 150200062800A R02 20 Mason • Irvine, CA 92618 • Phn: 949-679-8000 • www.smc.