User's Manual

C HAPTER 4 | Configuring the Switch
Configuring Local Port Mirroring
– 209 –
port mirroring is enabled on the Mirroring & RSPAN Configuration page,
mirroring will occur regardless of any configuration settings made on the
ACL Ports Configuration page (see "Filtering Traffic with Access Control
Lists" on page 96) or the ACE Configuration page (see "Configuring Access
Control Lists" on page 99).
PARAMETERS
These parameters are displayed:
◆ Session Number - A number identifying the mirror session. This
switch only supports one mirror session.
◆ Mode - Enables or disables port mirroring.
◆ Type - Select “Mirror” for local port mirroring.
◆ Port – Port identifier.
◆ Source - Sets the source port from which traffic will be mirrored.
Select one of these options:
■
Disabled - No frames are mirrored from this port.
■
Both - Frames received and transmitted on this port are mirrored to
the specified destination port.
■
Rx only - Frames received on this port are mirrored to the
destination port.
■
Tx only - Frames transmitted from this port are mirrored to the
destination port.
◆ Destination - Traffic from all configured source ports is mirrored to
this port. (Default: Disabled)
WEB INTERFACE
To configure local port mirroring:
1. Click Basic/Advanced Configuration, Mirroring & RSPAN.
2. Set the Mode to Enabled, and the Type to Mirror.
3. Set the type of traffic to mirror on the Source ports to be monitored.
4. Select to the Destination port to which all mirrored traffic will be sent.
5. Click Save.