User's Manual

C HAPTER 4 | Configuring the Switch
Link Layer Discovery Protocol
– 167 –
■
L2 Priority – Layer 2 priority used for the specified application
type. L2 Priority may specify one of eight priority levels (0 - 7), as
defined by IEEE 802.1D-2004. A value of 0 represents use of the
default priority as defined in IEEE 802.1D-2004.
■
DSCP – DSCP value used to provide Diffserv node behavior for the
specified application type as defined in IETF RFC 2474. DSCP may
contain one of 64 code point values (0 - 63). A value of 0 represents
use of the default DSCP value as defined in RFC 2475.
◆ Policy Port Configuration – Every port may advertise a unique set of
network policies or different attributes for the same network policies,
based on the authenticated user identity or port configuration.
■
Port – The port number for which the configuration applies.
■
Policy ID – The set of policies that apply to a given port. The set of
policies is selected by marking the check boxes that correspond to
the required policies.
WEB INTERFACE
To configure LLDP-MED TLVs:
1. Click Configuration, LLDP-MED.
2. Modify any of the timing parameters as required.
3. Set the fast start repeat count, descriptive information for the end-
point device, and policies applied to selected ports.
4. Click Save.