User's Manual

C HAPTER 4 | Configuring the Switch
Creating Trunk Groups
– 122 –
Aggregation Group Configuration
◆ Group ID – Trunk identifier.
◆ Port Members – Port identifier.
WEB INTERFACE
To configure a static trunk:
1. Click Configuration, Aggregation, Static.
2. Select one or more load-balancing methods to apply to the configured
trunks.
3. Assign port members to each trunk that will be used.
4. Click Save.
Figure 42: Static Trunk Configuration
CONFIGURING LACP Use the LACP Port Configuration page to enable LACP on selected ports,
configure the administrative key, and the protocol initiation mode.
PATH
Basic/Advanced Configuration, Aggregation, LACP
USAGE GUIDELINES
◆ To avoid creating a loop in the network, be sure you enable LACP before
connecting the ports, and also disconnect the ports before disabling
LACP.