User's Manual

C HAPTER 7 | Performing System Maintenance
Restoring Factory Defaults
– 290 –
RESTORING FACTORY DEFAULTS
Use the Factory Defaults page to restore the original factory settings. Note
that the LAN IP Address, Subnet Mask, and Gateway IP Address settings
are retained.
N OTE : You can also restore factory defaults by either pressing the switch
Reset button for more than six seconds, or for the 50-port switches,
connecting Port 1 to Port 2 and then performing a power reset.
PATH
Maintenance, Restart Device
WEB INTERFACE
To restore factory defaults:
1. Click Maintenance, Factory Defaults.
2. Click Yes.
The factory defaults are immediately restored, which means that no reboot
is necessary.
Figure 153: Factory Defaults
UPGRADING FIRMWARE
Use the Software Upload page to upgrade the switch’s system firmware by
specifying a file provided by SMC. You can download firmware files for your
switch from the Support section of the SMC web site.
PATH
Maintenance, Software Upload
WEB INTERFACE
To upgrade firmware:
1. Click Maintenance, Software Upload.
2. Click the Browse button, and select the firmware file.