User's Manual

C HAPTER 4 | Configuring the Switch
Configuring Loop Protection
– 124 –
WEB INTERFACE
To configure a dynamic trunk:
1. Click Configuration, Aggregation, LACP.
2. Enable LACP on all of the ports to be used in an LAG.
3. Specify the LACP Admin Key to restrict a port to a specific LAG.
4. Set at least one of the ports in each LAG to Active initiation mode,
either at the near end or far end of the trunk.
5. Click Save.
Figure 43: LACP Port Configuration
CONFIGURING LOOP PROTECTION
Use the Loop Protection page to detect general loopback conditions caused
by hardware problems or faulty protocol settings. When enabled, a control
frame is transmitted on the participating ports, and the switch monitors
inbound traffic to see if the frame is looped back.
PATH
Advanced Configuration, Loop Protection