User's Manual

A BOUT THE T IGER S WITCH 10/100/1000
1-6
Status LEDs
The LEDs, which are located on the front panel for easy viewing, are
shown below and described in the following table.
Figure 1-2. Port and System LEDs
Port Status LEDs
LED Condition Status
Gigabit Ethernet Ports (Ports 1~24)
Link/Act On/Flashing
Amber
Port has established a valid 10/100 Mbps
network connection. Flashing indicates
activity.
On/Flashing
Green
Port has established a valid 1000 Mbps
network connection. Flashing indicates
activity.
Off There is no valid link on the port.
FDX On Green Port is operating in full-duplex mode.
Off Port is operating in half-duplex mode.
SFP Transceivers Slots
(Ports 21~24) On Green An SFP transceiver port has established a
valid 1000 Mbps network connection. The
associated RJ-45 port is disabled.
Off An SFP transceiver port has no valid link.
The associated RJ-45 port is enabled.