Gigabit Ethernet Switch Management Guide

IP I NTERFACE C OMMANDS
4-284
Example
The following shows that port 11 in VLAN 1 is attached to a multicast
router.
IP Interface Commands
There are no IP addresses assigned to this switch by default. You must
manually configure a new address to manage the switch over your network
or to connect the switch to existing IP subnets. You may also need to a
establish a default gateway between this device and management stations
or other devices that exist on another network segment.
Basic IP Configuration
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
2 Eth 1/12 Dynamic
Console#
Table 4-52. Basic IP Configuration commands
Command Function Mode Page
ip address Sets the IP address for the current
interface
IC 4-285
ip dhcp restart Submits a BOOTP or DCHP client
request
PE 4-286
ip default-gateway Defines the default gateway through
which this switch can reach other
subnetworks
GC 4-286
show ip interface Displays the IP settings for this device PE 4-288
show ip redirects Displays the default gateway configured
for this device
PE 4-288
ping Sends ICMP echo request packets to
another node on the network
NE,
PE
4-289