Gigabit Ethernet Switch Management Guide

P RIORITY C OMMANDS
4-264
map ip port (Global Configuration)
Use this command to enable IP port mapping (i.e., class of service
mapping for TCP/UDP sockets). Use the no form to disable IP port
mapping.
Syntax
map ip port
no map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
Example
The following example shows how to enable TCP/UDP port mapping
globally:
map ip port (Interface Configuration)
Use this command to set IP port priority (i.e., TCP/UDP port priority).
Use the no form to remove a specific setting.
Syntax
map ip port port-number cos cos-value
no map ip port port-number
• port-number - 16-bit TCP/UDP port number. (Range: 0-65535)
• cos-value - Class-of-Service value (Range: 0-7)
Console(config)#map ip port
Console(config)#