Gigabit Ethernet Switch Management Guide

P RIORITY C OMMANDS
4-256
Priority Commands (Layer 2)
switchport priority default
This command sets a priority for incoming untagged frames. Use the no
form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames
received on the interface is zero.
Table 4-46. Priority Commands (Layer 2)
Command Function Mode Page
switchport priority
default
Sets a port priority for incoming untagged
frames
IC 4-256
queue mode Sets the queue mode to strict priority or
Weighted Round-Robin (WRR)
GC 4-258
queue bandwidth Assigns round-robin weights to the
priority queues
GC 4-259
queue cos map Assigns class-of-service values to the
priority queues
IC 4-260
show queue mode Shows the current queue mode PE 4-261
show queue
bandwidth
Shows round-robin weights assigned to
the priority queues
PE 4-262
show queue cos-map Shows the class-of-service map PE 4-262
show interfaces
switchport
Displays the administrative and
operational status of an interface
PE 4-181