Gigabit Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-154
snmp enable traps
This command enables this device to send Simple Network Management
Protocol traps (SNMP notifications). Use the no form to disable SNMP
notifications.
Syntax
[no] snmp enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
The link-up-down trap can only be enabled/disabled via the
CLI.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp enable traps command, no notifications
controlled by this command are sent. In order to configure this device
to send SNMP notifications, you must enter at least one snmp enable
traps command. If you enter the command with no keywords, both
authentication and link-up-down notifications are enabled. If you
enter the command with a keyword, only the notification type related
to that keyword is enabled.
•The snmp enable traps command is used in conjunction with the
snmp-server host command. Use the snmp host command to
specify which host or hosts receive SNMP notifications. In order to
send notifications, you must configure at least one snmp host
command.
Example
Console(config)#snmp enable traps link-up-down
Console(config)#