Gigabit Ethernet Switch Management Guide

OMMAND

INE

NTERFACE

4-152

Command Mode

Global Configuration

Example

Related Commands

snmp contact (4-151)

snmp host

This command specifies the recipient of a Simple Network Management

Protocol notification operation. Use the no form to remove the specified

host.

Syntax

snmp host host-addr community-string [version {1 | 2c}]

no snmp host host-addr

• host-addr - Internet address of the host (the targeted recipient).

(Maximum host addresses: 5 trap destination IP address entries)

• community-string - Password-like community string sent with the

notification operation. Although you can set this string using the

snmp host command by itself, we recommend that you define this

string using the snmp community command prior to using the

snmp host command. (Maximum length: 32 characters)

• version - Specifies whether to send notifications as SNMP v1 or

v2c traps.

Default Setting

Host Address: None

SNMP Version: 1

Command Mode

Global Configuration

Console(config)#snmp location WC-19

Console(config)#