Gigabit Ethernet Switch Management Guide

A UTHENTICATION C OMMANDS
4-105
authentication dot1x default
This command sets the default authentication server type. Use the no
form to restore the default.
Syntax
authentication dot1x default radius
no authentication dot1x
Default Setting
RADIUS
Command Mode
Global Configuration
Example
dot1x re-authentication Enables re-authentication for all ports GC 4-109
dot1x timeout
quiet-period
Sets the time that a switch port waits
after the Max Request Count has been
exceeded before attempting to acquire
a new client
GC 4-109
dot1x timeout
re-authperiod
Sets the time period after which a
connected client must be
re-authenticated
GC 4-110
dot1x timeout tx-period Sets the time period during an
authentication session that the switch
waits before re-transmitting an EAP
packet
GC 4-110
show dot1x Shows all dot1x related information PE 4-111
Console(config)#authentication dot1x default radius
Console(config)#
Table 4-25. 802.1x Port Authentication Commands
Command Function Mode Page