Gigabit Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-70
Example
Time Commands
The system clock can be dynamically set by polling a set of specified time
servers (NTP or SNTP), or by using information broadcast by local time
servers.
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP minimum severity level: 7
SMTP destination email addresses
-----------------------------------------------
[e-mail]
SMTP source email address: [e-mail]
SMTP status: Enable
Console#
Table 4-16. Time Commands
Command Function Mode Page
sntp server Specifies one or more time servers GC 4-71
sntp poll Sets the interval at which the client polls for
time
GC 4-72
sntp client Accepts time from specified time servers GC 4-72
sntp broadcast
client
Accepts time from any time broadcast server GC 4-74
show sntp Shows current SNTP configuration settings NE,
PE
4-74
clock timezone Sets the time zone for the switch’s internal
clock
GC 4-75
calendar set Sets the system date and time PE 4-76
show calendar Displays the current date and time setting NE,
PE
4-76