Gigabit Ethernet Switch Management Guide

C OMMAND L INE I NTERFACE
4-64
The following example displays settings for the trap function.
Console#show logging flash
Syslog logging: Enable
History logging in FLASH: level errors
[0] 0:0:5 1/1/1 "PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#show logging ram
Syslog logging: Enable
History logging in RAM: level debugging
[0] 0:0:5 1/1/1 PRI_MGR_InitDefault function fails."
level: 3, module: 13, function: 0, and event no.: 0
Console#
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
History logging in
FLASH
The message level(s) reported based on the logging history
command.
History logging in
RAM
The message level(s) reported based on the logging history
command.
Messages Any system and event messages stored in memory.
Console#show logging trap
Syslog logging: Enable
REMOTELOG status: disable
REMOTELOG facility type: local use 7
REMOTELOG level type: Debugging messages
REMOTELOG server IP address: 1.2.3.4
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
Console#
Field Description
Syslog logging Shows if system logging has been enabled via the logging on
command.
REMOTELOG
status
Shows if remote logging has been enabled via the logging
trap command.
REMOTELOG
facility type
The facility type for remote logging of syslog messages as
specified in the logging facility command.