Gigabit Ethernet Switch Management Guide

P ORT C ONFIGURATION
3-105
Command Attribute
Rate Limit – Sets the output rate limit for an interface.
Default Status – Disabled
Default Rate – 1000 Mbps
Range – 1 - 1000 Mbps
Web - Click Rate Limit, Input/Output Port/Trunk Configuration. Set the
Input Rate Limit Status or Output Rate Limit Status, then set the rate limit
for the individual interfaces, and click Apply.
Figure 3-46. Configuring Output Port Rate Limiting
CLI - This example sets the rate limit for input and output traffic passing
through port 1 to 600 Mbps.
Console(config)#interface ethernet 1/1 3-168
Console(config-if)#rate-limit input 600 3-186
Console(config-if)#rate-limit output 600
Console(config-if)#