Gigabit Ethernet Switch Management Guide

C ONFIGURING THE S WITCH
3-88
Statically Configuring a Trunk
Command Usage
• When configuring static trunks, you
may not be able to link switches of
different types, depending on the
manufacturer’s implementation.
However, note that the static trunks
on this switch are Cisco
EtherChannel compatible.
• To avoid creating a loop in the
network, be sure you add a static
trunk via the configuration interface
before connecting the ports, and also disconnect the ports before
removing a static trunk via the configuration interface.
Web – Click Port, Trunk Membership. Enter a trunk ID of 1-6 in the
Trunk field, select any of the switch ports from the scroll-down port list,
and click Add. After you have completed adding ports to the member list,
click Apply.
Figure 3-38. Static Trunk Configuration
active
links
}
statically
configured