Gigabit Ethernet Switch Management Guide

-182
show ip ospf neighbor
Use this command to display information about neighboring routers on
each interface within an OSPF area.
Syntax
show ip ospf neighbor
Command Mode
Privileged Exec
Example
State • Disabled – OSPF not enabled on this interface
• Down – OSPF is enabled on this interface, but interface is down
• Loopback – This is a loopback interface
• Waiting – Router is trying to find the DR and BDR
• DR – Designated Router
• BDR – Backup Designated Router
• DRother – Interface is on a multiaccess network, but is not the DR
or BDR
Priority Router priority
Designated Router Designated router ID and respective interface address
Backup Designated
Router
Backup designated router ID and respective interface address
Timer intervals Configuration settings for timer intervals, including Hello, Dead and
Retransmit
Console#show ip ospf neighbor
ID Pri State Address
--------------- ------ ---------------- ---------------
10.1.1.252 1 FULL/DR 10.1.1.252
Console#
Field Description
ID Neighbor’s router ID
Pri Neighbor’s router priority
Field Description