Gigabit Ethernet Switch Management Guide

W EB I NTERFACE
3-11
IP Configuration
Use the IP Configuration screen to set the bootup option, configure
the Ethernet IP address for the switch, or set the number or
concurrent Telnet sessions allowed. The screen shown below is
described in the following table.
Parameter Default Description
IP State USER-
CONFIG
Specifies whether IP functionality is
enabled via manual configuration, or
set by Boot Protocol (BootP).
Options include:
BOOTP Get IP - IP is enabled but
will not function until a BootP reply
has been received. BootP requests
will be periodically broadcast by the
switch in an effort to learn its IP
address. (BootP values include the IP
address, default gateway, and subnet
mask.)
USER-CONFIG - IP functionality is
enabled based on the default or user
specified IP Configuration. (This is
the default setting.)