Gigabit Ethernet Switch Management Guide

W EB I NTERFACE
3-9
System Information
Use the System Information screen to display descriptive information
about the switch, or for quick system identification as shown in the
following figure and table.
Parameter Description
System Name
1
Name assigned to the switch system.
IP Address
2
IP address of the switch you are managing. The
switch’s management supports SNMP over UDP/IP
transport protocol. In this environment, all systems on
the Internet, such as network interconnection devices
and any PC accessing the switch must have an IP
address. Valid IP addresses consist of four decimal
numbers, of 0 to 255, separated by periods. Anything
outside of this format will not be accepted by the
configuration program.
Object ID MIB II object identifier for switch’s network
management subsystem.
Location
1
Specifies the area or location where the system resides.
Contact
1
Contact person for the system.
System Up Time Length of time the current management software has
been running.
1
Maximum string length is 255, but the screen only displays 45 characters.
You can use the arrow keys to browse the whole string.
2
The default value is 10.1.0.1