Gigabit Ethernet Switch Management Guide

W EB I NTERFACE
3-7
Main Menu
Using the onboard Web agent, you can define system parameters,
manage and control the switch, and all its ports, or monitor network
conditions. The interface screen includes the main menu on the left
side, the menu bar beneath the image of the switch, and a list of
commands beneath the menu bar. The following table briefly
describes the selections available from this program.
Function Description
System Provides basic system description, including contact
information.
Switch Shows hardware/firmware version numbers and power
status of the switch.
IP Includes boot state, IP address, and Telnet session count.
SNMP Configures communities and trap managers; and
activates traps.
Security Sets password for system access.
Upgrade Downloads new version of firmware to update your
system.
Configure Saves the switch configuration to a file on a TFTP server.
This file can be later downloaded to restore the
configuration
Address Table Provides full listing or unicast addresses, sorted by
address or VLAN.
STA Enables Spanning Tree Algorithm; also sets parameters
for switch priority, hello time, maximum message age,
and forward delay; as well as port priority and path cost.
Bridge
Extension
Displays/configures extended bridge capabilities
provided by this switch, including support for traffic
classes, GMRP multicast filtering, and VLAN
extensions.
Priority Configures default port priorities and queue
assignments.