Wireless Cable Router User Manual

APPENDIX A | Telnet and SSH CLI Commands
Refer to the Remote Management section in Chapter 6 to enable and configure Telnet and
SSH settings.
Refer to the 8014 CLI document for command specifics.
To remotely access the CLI of the SMC8014W-G via Telnet, open a DOS/Command Prompt
and type: telnet IP remote mgmt port Enter
• NOTE: Telnet remote management is not enabled by default. To enable, first log into
the Gateway via the HTTP web admin page and go to System/Remote Management and
select the check box next to Telnet Port
• For example, open a command prompt and type: telnet
xxx.xxx.xxx.xxx 2323 Enter
(where xxx.xxx.xxx.xxx is your WAN IP listed on the status page)
• Enter the same user and password as used for the GUI/HTTP
• Commands are case sensitive
• Type help and then Enter for a list of commands
Use an SSH client of your choice for SSH remote management.