User's Manual

User Manual
14
8.1.2 Rear Panel
Figure 2 Rear panel
The following table describes the interfaces and buttons on the rear panel.
Interface
Description
Line
RJ-11 port for connecting to the ADSL interface or a splitter through a
telephone cable.
WLAN WLAN switch for enabling or disabling the WLAN function.
Reset
Press the button for at least 3 seconds and then release it. System
restores the factory default settings.
WPS
Enables WPS PBC mode. When WPS is enabled, press this button
for the wireless router to start the negotiation of PBC mode.
LAN 4~1
RJ-45 ports for connecting the router to PCs or other network
devices.
USB
USB host port for connection to a USB device to support a specific
value-added application.
Power
For connecting the AC power adapter to supply 12 V DC, 1 A.
Power on/off switch, next to the power socket.
Warning:
Do not press the Reset button unless you want to clear the current settings. The
Reset button is in a small circular hole on the rear panel. If you want to restore the
default settings, press the Reset button for 3 seconds with a fine needle inserted into
the hole and then release the button. The system reboots and returns to the factory
defaults.
The power specification is 12V, 1A. If the power adapter does not match the
specification, it may damage the device.